Filter
Top Products
Setup
8
9. Turn power switch ON.
10. Close gun air valve.
11. Point gun into waste bucket and pull trigger to pump
water through the system. Continue to trigger gun
until material hopper is empty.
12. Add pre-mixed texture mix to material hopper. See
Mixing Material, page 10.
13. Continue to trigger gun and spray into waste bucket
until a steady stream of material sprays out of gun.
14. Release trigger. To achieve uniform spray pattern,
adjust air valve and flow adjustment nut on gun. If
you do not achieve the desired pattern, change noz-
zles, page 11.
Touch Up Hopper Attachment
1. Connect air hose to sprayer.
2. Connect air hose to gun.
3. Slide hopper on top of gun, and tighten clamp.
4. Install spray nozzle. Page 11.
5. Fill Touch-up hopper with pre-mixed texture. See
Mixing Material, page 10.
Fluid flow will be restricted if the material hose is
kinked.
ti9222a
ti8712a
ti9084a
ti8532a
CAUTION
Failure to change selector switch to Hopper Gun when
using hopper gun will damage pump hose.
The Hose Plug must be
securely fastened to bottom
of gun when using the
Touch Up Hopper. Gun plug
must be removed from top
of gun.
ti8701a
ti8534a
ti8535a
ti2559a