Filter
Top Products
4
308-457
FIRE AND EXPLOSION HAZARD
Improper
grounding, poor air ventilation, open flames or sparks can cause a hazardous condition
and result in a fire or explosion and serious injury
.
D
Ground the equipment and the object being sprayed. See
Ground the system
on 6.
D
If there is any static sparking while using the equipment,
stop spraying immediately
. Identify
and correct the problem.
D
Provide fresh air ventilation to avoid the buildup of flammable vapors from solvent or the fluid be
-
ing sprayed.
D
Do not smoke in the spray area.
D
Extinguish all open flames or pilot lights in the spray area.
D
Do not turn on or of
f any light switch in the spray area.
D
Electrically disconnect all equipment in the spray area.
D
Keep the spray area free of debris, including solvent, rags and gasoline.
D
Do not operate a gasoline engine in the spray area.
EQUIPMENT MISUSE HAZARD
Equipment
misuse can cause the equipment to rupture, malfunction or start unexpectedly and result
in serious injury
.
D
This equipment is for professional use only
.
D
Read all instruction manuals, tags, and labels before operating the equipment.
D
Use the equipment only for its intended purpose. If you are in doubt about this, call Graco T
echni-
cal Assistance at 1–800–543–0339.
D
Do not alter or modify this equipment. Use only genuine Graco parts and accessories.
D
Check equipment daily
. Repair or replace worn or damaged parts immediately
.
D
Do not exceed the
2760 psi (190 bar) maximum working pressure at 120 psi (8.3 bar) maxi
-
mum incoming air pressure
of the pump, or the maximum working pressure of any accessory
used with it.
D
Do not move or lift pressurized equipment.
D Use
fluids or solvents which are compatible with equipment
wetted parts. Refer to the
T
echnical Data
section
of all equipment manuals. Read the fluid and solvent manufacturer
’
s warnings.
D
Fluid hoses must have spring guards on both ends to protect it from rupture caused by kinks or
bends at or close to the couplings.
D
Comply with all applicable local, state and national fire, electrical and other safety regulations.
D
Do not touch the heater during operation; it is very hot.
MOVING
P
ARTS HAZARD
Moving
parts, such as the air motor piston located behind the air motor plates, which can pinch or
amputate fingers.
D
Never operate the equipment with the air motor plates removed.
D
Keep clear of any moving parts when starting or operating the equipment.
WARNINGWARNING