Filter
Top Products
Shutdown and Cleaning
3A0159E 17
7. Discard contaminated fluid and refill with appropri-
ate flushing fluid.
8. Disengage trigger lock, reverse tip to UNCLOG
position, and pull trigger for 5 seconds to prepare
sprayer.
9. Put control lever DOWN to spray position.
Trigger sprayer into waste area until no paint
appears in water or flushing fluid.
10. Engage trigger lock and put control lever UP to
release pressure.
11. Remove material cup and discard used fluid.
12. Use a soft brush to clean the black rubber inlet seal.
If the vent holes become clogged, use the Fine Fin-
ish Optimizer cleaning tool or a paper clip to clear
the holes.
13. Remove Spray Tip/Guard Assembly and clean with
water or flushing fluid. A soft brush can be used to
loosen and remove dried material if needed. Run
underwater and use a soft brush to clean the filter.
14. Replace tip assembly.
15. If you used the Fine-Finish Optimizer, remove and
clean optimizer with water (or flushing fluid) and a
brush. Reconnect intake tube.
To avoid serious injury or damage to equipment, do not
expose the sprayer electronics to flushing solvents.
Keep sprayer at least 10 in. above the rim of the con-
tainer when flushing.
Keep spray area well-ventilated. Keep a good supply
of fresh air moving through the area.
ti14995a
ti14991a
ti15425a
ti15491a
ti15529a
ti14994a
ti14999a
NOTICE
The tip is a permanently attached to the guard.
Removing the tip from the guard will result in damage
to tip assembly.
ti15003a