Filter
Top Products
Contents
Install Air Co
mpressor......................................... 2
Install Air Tank ................................................... 3
Connect Air Lines ............................................... 3
Connect Power
Cable ......................................... 5
Parts.................................................................. 7
Graco Standard Warranty.................................... 10
Install Air Compressor
Reference
parts illustration, Parts, page 7 .
1. Remove the battery bracket and fuel tank. See
system repair manual for instructions.
2. Turn the B side y-strainer inlet on the Reactor
as shown.
NOTICE
Be careful to not damage engine components.
3. Loosely assemble the front bracket (2) to pallet
using two screws (10).
4. Install the side support gusset (5) to the pallet
with four screws (10) and nuts (11) as shown. Do
not tighten the screws.
5. Install the rear bracket (1) on the pallet with five
screws (9) and nuts (11). Do not tighten the
screws.
6. Install the six screws (10) and nuts (11) through
the top of the support gusset (5). Do not tighten
the screws.
7. Assemble the top plate assembly (3) to frame
with 14 screws (9) and nuts (11). Do not tighten
the screws.
8. Lift side o
f gusset (5) to ensure top plate (3) is
level bef
ore tightening. Tighten all screws and
nuts.
9. Install f
our isolators (8) with screws (10) on top
plate ass
embly (3).
Use lifting device to prevent personal injury
when lifting the compressor. Do not overlap
lifting straps over tubing or other fragile
components.
10. Lift the air compressor (7) onto the isolators (8).
Secure the air compressor to the isolators with
four screws (28), washers (29).
11. Install elbow adapter (13) in air compressor
outlet.
12. Remove plug and install elbow fitting (41) on
compressor pilot valve (see parts illustration).
13. Remove compression nut cap and install
compression nut fitting (37). Tighten finger tight
only.
14. Install end caps (32).
2
3A1902C