Filter
Top Products
Installation
To reduce the risk of injury, follow the Pressure
Relief Procedure in your Pro Xp manual before
installing this kit.
1. Relieve the pressure.
2. Remove the retaining ring, air cap/tip guard, and
spray tip.
3. Flush the gun as instructed in your gun manual.
Relieve the pressure.
NOTICE
Do not operate the gun with a damaged
electrode (4a). Make sure the electrode is in
place before installing the air cap/electrode
assembly (4).
NOTE: The kit
includes a large retainer (2) for
a larger patt
ern, and a small retainer (3) for a
smaller pat
tern.
4. Check that t
he electrode (4a) is in place in the air
cap. The two
ends of the electrode should be
inserted i
n the two holes on the back of the air
cap, and sh
ould protrude through the front of the
air cap. In
stall the diffuser/seal assembly (1), air
cap/elect
rode assembly (4), and desired retainer
(2 or 3) ont
o the gun. Tighten the retainer firmly.
2
3A2499B