Graco 3A2499B Paint Sprayer User Manual


  Open as PDF
of 6
 
Installation
NOTICE
Overtightening the spray tip (5) can damage
the tip and cause poor spray performance.
5. Install the s
pray tip (5) and tighten using the
wrench (6). W
hen tightening, only grip the end
of the wrench
with your fingers. Do not grip the
wrench cross
-arms (E).
6. Adjust the spray pattern as explained in the Gun
Setup Checklist of your Pro Xp gun manual.
NOTE: The recommended spraying distance
from the front of the gun to the object being
sprayed is 8–12 in. (203–305 mm). Round spray
tips emit a soft pattern. If the gun is too far from
the object, the floating charged particles may be
attracted to the gun or operator instead of to the
grounded object.
NOTE: See Round Spray Tips, page 5 ,
for fluid flow information. See
Spray Pattern Troubleshooting, page 5 ,
to correct spray pattern problems.
NOTE: If the spray tip clogs, stop spraying
immediately and relieve pressure. Clean the tip
as explained in your Pro Xp gun manual. To help
reduce spray tip clogging, clean or replace the
fluid filter supplied with the gun.
3A2499B 3
 previous next