Filter
Top Products
30897210
Operation
Pressure Relief Procedure
WARNING
S
K
IN INJECTION H
A
Z
A
RD
The system pressure must be manually
relieved to prevent the system from
starting or spraying accidentally. Fluid
under high pressure can be injected through the
skin and cause serious injury. To reduce the risk of
an injury from injection, splashing fluid, or moving
parts, follow the Pressure Relief Procedure
whenever you:
D areinstructedtorelievethepressure,
D stop spraying,
D check or service any of the system equipment,
D install o r clean the spray tip.
1. Engage the gun safety latch.
2. Open the bypass valve.
3. T urn the ignition key to OFF.
4. Disengage the gun safety latch. Hold a metal part
of the gun firmly to the side of a g rounded metal
pail, and trigger the gun to relieve pressure.
5. Engage the gun safety latch.
6. Open the pressure drain valve, having a container
ready to catch the drainage. Leave the valve open
until you are ready to spray again.
If you suspect that the spray tip or hose is completely
clogged, or that pressure has not been fully relieved after
following the steps above, wrap a rag around the tip
guard retaining nut or hose end coupling and VERY
SLOWLY loosen the part to relieve pressure gradually,
then loosen completely. Now clear the tip or hose.
1. Prepare the Fluid
a. Prepare the fluid according to the fluid manu-
facturer’s recommendations.
b. Place the pump or suction tube into the fluid
container.
2. Starting the Sprayer
a. Open the bypass valve to make startup easier.
In the open position, the valve lever i s parallel
to the body of the valve. See Fig 6. Close the
filter drain valve.
b. Turn the pressure control knob counterclock-
wise until all spring tension is relieved. You will
be able to feel it. The sprayer is now set at the
lowest pressure setting. Turning the knob fur-
ther will cause it to fall off.
c. Attach fuel hose from tank.
d. If the engine is cold, close the choke by mov-
ing the choke lever . See Fig 6.
3. T urn and hold the ignition key to STA RT until you
hear the engine “catch”, then release the key to
RUN. See Fig 6. If the engine does not start,
open t he choke a little (move choke lever). If the
engine floods, open the choke a ll the way and try
again.
e. After the engine is warm, gradually open the
choke lever (move choke lever) and close the
bypass valve. See Fig 6.
Fig 6
7874b
PRESSURE
CONTROL
KNOB
BYPASS
VALVE
ON/OFF
SWIT CH
AIR FILTER
CHOKE
NOTE: In cold weather, run the engine f or about 15
minutes with the bypass valve open before
starting the displacement pump, to help avoid
hydraulic motor stalling.
f. Follow the Pressure Relief Procedure
Warning on page 10, to shut off the sprayer.
WARNING
To stop the engine in an emergency, turn OFF
the ignition key. Close the bypass valve if possible.
See Fig 6. Then follow the Pressure Relief Proce-
dure Warning on page 10.