Graco 965165 Paint Sprayer User Manual


 
5308972
Component Identification
Fig 1
9089d
HYDRAULIC SUPPLY LINE TO MOTOR
HYDRAULIC
RESERVOIR
GASOLINE
FILL CAP
MOTOR RESET BUTTON
HYDRAULIC MOTOR
HYDRAULIC
PUMP
SUCTION HOSE
SUCTION TUBE
PRESSURE
CONTROL KNOB
CHECK
VALVE
DISPLACEMENT PUMP
H
Y
DR
A
ULIC RETURNLINE TOMOTOR
PRESSURE
DRAIN VALVE
Setup
1. Connect the Hose and Gun
a. Remove the plastic cap plug from the outlet
tee and screw an accessory, conductive or
grounded spray hose onto the 1/4 npsm(f) out-
let nipple. See Fig 1.
b. Connect a small diameter, 3 ft (0.9 m) whip
hose between the main hose and a spray gun,
if desired, for more flexible gun movement.
See Fig 1.
c. Don’t use thread sealant on the swiveling nut
of the hose couplings, and don’t install the
spray tip yet.
NOTE: Use thread sealant on all male threads except at
swivel unions. Swivel unions are made to self--
seal, and using thread sealant prevents the
swivel from turning freely.
2. Fill the Packing Nut/Wet Cup 1/3 full with Graco
Throat Seal Liquid (TSL), supplied. See Fig. 2.