Filter
Top Products
Removing and Replacing Hopper, Front and Back Covers
10 310645S
Back Cover
To access the motor and all other components, it is nec-
essary to remove the hopper, front and back covers.
Removing Cover
1. Completely
remove 6
screws (2 on
top and each
side) from
cover.
2. Lift cover up
and then tilt it
back and off
sprayer frame.
Replacing Cover
1. To reposition
cover on sprayer
frame, tip the
cover back,
toward you and
slide it down, into
place in the base
of the frame. Then
push the top back
into place. Align
screw holes in
side and top of
cover with holes in
frame.
2. Replace and
tighten screws.
ti4430a
ti4431a
ti4432a
ti4433a