Mounting Hole Layout
311052H 37
Mounting Hole Layout
FIG. 25:
TI8107a
0.4 in. (10.2 mm)
(6.3 mm) holes
0.805 in. (20.5 mm)
0.187 in. (4.8 mm)
1.375 in.
(35 mm)
2.125 in.
(54 mm)
TI8127a
1.750 in.
(44.5 mm)
Two M5 x 0.8 x 0.25 in.
Two 0.128 diameter x
0.31 in. (7.8 mm) deep
holes (for alignment pin)
Remove set screws
when using bottom
mounting pattern.
0.5 in. (12.7 mm)