Filter
Top Products
Setup
309915D 7
Setup
Preparation
4 Connect air and material
hoses to gun. Tighten
securely).
5 Connect one end of material
hose (cc) to material outlet (K
or L) and the other end to gun
material inlet (bb).
NOTE: Material plug must be
installed in material outlet (K or
L) you are not using.
6 Open gun air valve (23). 7 Check engine oil level. Add
SAE 10W-30 (summer) or
5W-20 (winter) oil, if neces-
sary.
8 Fill fuel tank (A) (Fueling, page
13).
Removing & Installing Hopper
Removing Hopper (G) Installing Hopper (G)
The hopper (G) can be removed
from cart for cleaning and when
using the Siphon Kit 248112,
available from your Graco
distributor.
1 Push down 2 latches on each
side of hopper coupler (H).
Lift hopper (G) straight up, off
of unit.
2 Position coupler (H) over material outlet and slide hopper (G)
straight down, over the fitting as far as it will go, making sure hopper
bracket is positioned over cart handle rod.
Secure latches on each side by pushing them, firmly up, into locked
position.
ti4003a
WLE
N
dd
cc
K
L
23
ti3908a
A
TI3056A
ti3900a
ti3899a
H
G
ti3902a
H
G
ti3925a