Filter
Top Products
Setup
8 309915D
Compressor Power
Pack
Removing Compressor Power Pack (Z)
For outdoor use, the compressor
power pack (Z) can be left on the
cart.
For indoor use, the compressor
power pack (Z) must be separated
from the sprayer and placed
outdoors, A longer air hose (not
provided) must be used to connect
the sprayer to the compressor
power pack (Z). See Running
Compressor Remotely, page 8.
1 Disconnect air line quick
connect fitting (Q) from
compressor air quick connect
inlet fitting (V).
2 Loosen motor lock knob (S) by
turning it counter-clockwise,
relieving tension on bracket.
3 Push knob down.
CAUTION Running Compressor Remotely
4 The compressor power pack
(Z) slides off the back of the
cart.
Place compressor power pack
on a hard, level surface where
cooling air can circulate freely
through cooler and a minimal
amount of dirt and dust is drawn
into it. Placing compressor
power pack on a soft, uneven
surface such as dirt, grass or
sand, can plug air cooler (M),
resulting in overheating and
damage to motor.
1 A longer air hose (not
provided) must be used to
connect the sprayer to the
compressor power pack (Z)
when the two components are
separated.
(Hose Kit 248117,
containing a 50 ft hose is
available from your Graco
distributor.)
2 Attach the longer air hose to
the air line quick connect fitting
(Q) and to the compressor air
quick connect inlet fitting (V).
Q
V
ti3784a
S
ti3891a
Z
ti3959a