Filter
Top Products
Setup
313888B 13
Air Assisted Spray (Base Coat Applicator)
1. Prepare material, page 11. Place material hose in
supply pail.
2. Turn on/off switch OFF.
3. Remove cap before installing air line.
4. Turn air valve OFF. Connect applicator to material
hose and air hose. Air supply minimum require-
ments vary with material thickness and desired
thickness.
5. Turn on/off switch ON.
6. Hold applicator over material pail and turn pump ON
using applicator switch on hose.
7. Turn pump control clockwise until desired material
delivery rate is achieved.
8. Spray test pattern. Aim applicator at floor. Turn air
valve ON. Move applicator to spray surface.
9. Adjust air valve and/or select alternative nozzle size
(4 - 10mm) for desired finish.
NOTICE
DO NOT USE MATERIALS THAT CURE RAPIDLY!
Materials with a fast curing time could plug the pump
hose, gun, or applicator.
ti4650a
ti10796b
ti13647a
ti14358a
ti13636a
ti10795b
ti13641a
ti8794a
ti13646a
ti11798a
6 mm
8 mm
10 mm
4 mm