Filter
Top Products
30940820
Caution: If flushing with water, do not leave water in sprayer. Flush again with mineral
spirits, oil or Pump Armor and leave this protective coating in the sprayer to help
prevent freezing or corrosion and increase sprayer life.
13.Raise siphon tube above flushing fluid
and run sprayer for 15 to 30 seconds to
drain fluid. Turn pump switch OFF. Turn
engine OFF.
14.Make sure plastic center tube is tightened
securely. Install filter bowl and filter. Hand
tighten filter bowl. Hand tighten gun han-
dle.
15.Wipe sprayer, hose and gun with a rag
soaked in water or mineral spirits.
16.Clean tip, guard and gasket with a soft
bristle brush to prevent part failure due
to dried materials. Assemble parts and
attach loosely onto gun.
PAINT
FLUSH
FLUSH