Filter
Top Products
309412 15
Displacement Pump
Removal
See manual 309277 for pump repair instructions.
1. Flush pump.
2. Fig. 9. Cy cle pump with piston rod (222) in lowest
position.
3.
Relieve pressu re; page 4.
4. Fig. 9. Remove suction tube (30) and hose (33).
9024B
Fig. 9
222
33
30
9024C
5. Fig. 10. Use screwdriver to push out pump
pin (101).
Fig. 10
101
71a
Detail A
9019B
6. Fig. 11. Loosen locknut by hitting firmly with a
20 oz (maximum) hammer. Unscrew pump.
9022A
Fig. 11
Repair
Installation
WARNING
If pin works loose, parts could b reak off due to
force o f pumping action. Parts could project
through the a ir and result in serious injury or prop-
erty damage. Make sure pin (101) and retaining
clip (71a) are properly installed. See Detail A. Fig.
10.
C
A
UTION
If the pump locknut loosens during operation, the
threads of the bearing housing will be damaged.
Make sure locknut is properly tightened.
1. Fig. 12. Pull piston rod out 1.0 in. Screw in pump
until holes in housing plates and piston rod a lign.
Fig. 12
1.0 in.
9020A
2. Fig. 10. See D etail A. Push pin (101) into hole
until retaining clip (71a) snaps over pin.
Fig. 13. Screw jam nut down onto pump until nut
stops. Screw pump up into pump plate until it stops.
Back off pump one full turn and align pump outlet to
back. Tighten jam nut by hand, then tap 1/8 to 1/4 turn
with a 20 oz (maximum) hammer to approximately 75
±5ft--lb(102N¡m).
9021A
Fig. 13
Fig. 14. Fill packing nut with Graco TSL until fluid flows
onto the top o f seal.
Fig. 14
9023A