Filter
Top Products
308438 15
Service
Fig. 19
24
03971
7. Install the screws (24). See Fig. 19.
29
28
27
18
25
03970
Fig. 20
A
B,16
8. Position the trigger (25) on the gun body. Insert the
pivot pin (28) into the top hole (A) and secure with
the screw (29) on the other side. Place an e-clip
(27) on one end of the trigger pin (18). Slide the
pin through lower trigger holes and through the
hole (B) in the spring guide (16) (turn the spring
guide to align, as needed). Install the other e-clip
(27). See Fig. 20.
Fig. 21
1
21
Turn in until screw
stops
1
03980
9. If it was removed, install the spring tension screw
(21) at the rear of the gun. Then, turn the screw in
until it stops. See Fig. 21.
Test the Gun Before Regular Use
1. Lock the gun trigger safety. Connect a hose to the
gun. Start and prime the pump.
2. Release the gun trigger safety. Trigger the gun into
a waste container. Release the trigger to be sure
the gun immediately stops spraying and that there
are no leaks.
3. If the gun has a diffuser, check the diffuser using
the procedure on page 11.
4. Install the tip guard before regular use. See
Fig. 22.
Fig. 22
03965