Filter
Top Products
311977C 3
Maintenance
Before performing any maintenance on gun, read all warnings
on front cover of this manual and relieve pressure.
Cleaning/Replacing Filter (19)
1. Relieve pressure. Set trigger lock.
2. Unscrew hose from gun at gun swivel.
3. Remove filter (19).
4. Clean filter. Use a soft brush to loosen and remove excess
debris.
5. Insert clean filter into handle.
Cleanup
Flush gun after each work shift and store in a dry location.
To clean the handle grip, use water and a brush. For tougher
stains, use a rag wetted in paint thinner or mineral spirits to
scrub off paint. Do not operate until solvents have evaporated.
To preserve life of the handle grip, do not stretch or pull grip
from edges
Ref
No. Part. No. Description Qty
15 237859 GUARD, RAC IV;
7/8 in. (22 mm) thread
1
16 221515 TIP, spray, 515, 0.015 in. (0.381 mm)
orifice; 10-12 in. (254-304.8 mm) fan
(includes 17a and 17b)
1
17 243004 KIT, repair, gasket (includes 17a to 17b) 1
17a GASKET, tip, black rubber 1
17b SEAT, cylinder 1
19 288748 FILTER, 2-pack, 60 & 100 mesh 1
15
17b
17a
16
19
Always replace the gasket and
seat (included with tip) when you
replace a worn spray tip. See
Installing Tip (16) and Guard
(15) on Gun, page 2.
Clean the spray gun fluid filter
with compatible solvent and a
brush every time you flush the
system.
1
2
1
1
2
ti8920a
WARNING
CAUTION
• Never soak gun in solvent.
• Do not leave the gun or any parts in water or clean-
ing solvents.