Filter
Top Products
Setting/Replacing
Knives
Planer knives are extremely sharp and can
quickly cause a serious injury to your hands
or fingers. Always wear heavy leather gloves
when handling these knives to reduce the
risk of cutting injuries.
Note: If you need to replace or sharpen a knife,
you can remove the knife from the cutterhead dur-
ing Step 4 of the following procedure. Thoroughly
clean out any debris from the knife slots before
replacing the knives.
Replacement knives are available through Grizzly
(refer to Page 28 for options).
Tools Needed Qty
To adjust the height of the knives:
1.
2.
3.
Note for G0454 Only: The cutterhead for
the Model G0454 ships with both springs and
jack screws to adjust the knife height (see
Figure 34—which one you use is up to your
personal preference. However, you should
remove the components that you will not use
from the cutterhead before proceeding.
Jack Screw
(G0454 Only)
Gib
Gib Bolt
Spring
Knife
Loosen
Tighten
Figure 34.
4.
Figure 35
Figure 35.