Grizzly G0457 Saw User Manual


  Open as PDF
of 64
 


Blade Tensioning


     
      


To tension the bandsaw blade:
1. Test Run
Page 21

2.       
  


Note: This procedure will NOT work if the
guide blocks have any contact with the
blade.
3.        


Note: This scale can only be considered a
general guide. Complete the following steps
to accurately set blade tension.
4. ON
5.   
   


6.       


7.        


Note: Always de-tension the blade after use
to increase blade life and reduce strain on the
bandsaw components.
NOTICE
After blade tension and tracking are set cor-
rectly, you MUST properly adjust the upper
and lower support bearings and guide-block
assemblies into position before cutting.
Adjusting Support
Bearings
     
      




To adjust the support bearings:
1. 

2. 
3. 
Figure 29
Figure 29.






 previous next