Filter
Top Products
G0505 12
1
⁄2" Lean & Mean Portable Planer
-11-
Mounting to Bench
The planer can be directly mounted to a bench or
table top, or to a Shop Fox
®
Deluxe Tool Table for
increased stability during planing.
To mount the planer:
1. Determine the correct length of hex bolts
needed to mount the planer to your work-
bench. This will be the height of the planer
mounting holes, plus the thickness of your
workbench, plus an extra
1
⁄2" for washers and
the hex nut.
2. From the hardware store, get (4)
1
⁄8" hex bolts
that meet the length requirements for your
setup. Also get (8)
1
⁄2" flat washers, (4)
1
⁄2"
lock washers, and (4)
1
⁄2" hex nuts.
3. Mount the planer to your workbench with
your hardware in the order shown in Figure
3.
Figure 4. Attaching handle.
Figure 3. Mounting planer to bench.
Handle Assembly
To attach the handle assembly:
1. Align the flat portion inside the handle bore
with the flat portion on the shaft.
2. Insert the handle assembly on the shaft that
protrudes out of the top of the planer (see
Figure 4).
3. Thread the M5-.8 x 20mm cap screw through
the handle and into the shaft to secure the
handle in place. DO NOT over-tighten.
Planer Mounting
Hole
Workbench