Filter
Top Products
18" & 20" Super Heavy-Duty Bandsaws -7-
Model G0511
The Model G0511 Bandsaw is pre-wired for 3-
phase, 220V operation. Under normal use, the 5
HP motor draws approximately 13 amps. We rec-
ommend using a 15 amp circuit, including a 15
amp circuit breaker, plug, receptacle and wiring
rated for at least 15 amps. If frequent circuit
breaker failures occur when using the bandsaw,
contact our service department.
This bandsaw must be connected to its own ded-
icated circuit. It should not share a circuit with any
other machine. A standard 3-pole breaker is nec-
essary for use with the Model G0511.
This bandsaw is not supplied with a cord and
power plug. We recommend using a NEMA-style
L15-20 plug and outlet, similar to
Figure 2. You
may also “hard-wire” the bandsaw directly to your
panel, provided you place a disconnect near the
machine. Check the electrical codes in your area
for specifics on wiring requirements.
Please refer to the wiring diagram on page 31 for
power hook-up information.
Figure 2. Typical plug configuration for 220V,
three-phase operation.
440V Operation
The Model G0511 Bandsaw is furnished with a 3
HP 3-phase motor that can be wired to 440V.
Under normal use, this motor draws approxi-
mately 6.5 amps at 440V. If 440V operation is
desired, we recommend using a 10 amp circuit
that includes the appropriate wiring, plug and cir-
cuit breaker. If frequent circuit failures occur
when using the bandsaw, contact our service
department.
The bandsaw must be connected to its own ded-
icated 10A circuit. It should not share a circuit
with any other machine. A standard 3-pole break-
er is necessary for 440V use.
We recommend using a NEMA-style L16-20 plug
and outlet similar to that in
Figure 3. You may
also “hard-wire” the bandsaw directly to your
panel, provided you place a disconnect near the
machine. Check the electrical codes in your area
for specifics on wiring requirements.
If you convert the bandsaw to 440V, the stock
magnetic switch must be replaced with a dif-
ferent magnetic switch specifically for 440V
use. The 440 magnetic switch is not included
with your bandsaw.
Figure 3. Typical plug configuration for 440V,
3-phase operation.