Grizzly G0598 Grinder User Manual


 
-10-
G0596-G0599 Industrial Bench Grinders
Inventory
After all the parts have been removed from the
box you should have the following items:
Box 1: Qty
A. Grinder .......................................................
1
B.
Wrench 25mm (G0596/G0597) .................. 1
C.
Wrench 50mm (G0598/G0599) .................. 1
NOTICE
Some hardware/fasteners on the inventory
list may arrive pre-installed on the machine.
Check these locations before assuming that
any items from the inventory list are miss
-
ing.
Mounting
Mount the grinder on the optional H7834 stand
(see Page 17), or a workbench that is sturdy
enough to hold the weight of the machine and
any downward pressure that may be applied dur
-
ing operation.
The stand or workbench should be level, rigid,
and attached to the floor, so it will not move dur
-
ing operation.
For proper safety, drill holes in your workbench
and secure the grinder with hex bolts, washers,
and hex nuts, or with lag screws and flat wash-
ers. (Mounting hardware is not provided due to
the many possible set ups and workbench thick
-
nesses.)
When locating your grinder, remember:
You will need room for potentially large
workpieces.
Maintain easy access to dust ports for attach
-
ing dust collection system.
Grinding without dust collection system
spreads dust in the immediate vicinity of the
grinder.
Grinding creates flying sparks that MUST be
out of reach of any flammables.
You will need a lot of light around the
grinding wheel in addition to the lighted eye
shields.
Eye Shields
The eye shields on the Model G0596/G0597/
G0598/G0599 may come pre-mounted from the
factory. If they do not, attach them at this time with
the two Phillips head screws provided.
Figure 4. Eye shield.
Light Switch
DO NOT operate this grinder without the eye
shields or wheel guards in place. Failure
to properly use these safety devices could
lead to serious injury!
Mounting Screws