Filter
Top Products
Fence Components
To install the fence knobs, fence, and fence
resting brackets:
1. Figure
30
Figure 30
2.
3.
Adjusting FencePage 56
4. Figure
31
Figure 31
Dust Collection
DO NOT operate the Model G0651/G0652
without an adequate dust collection system.
This saw creates substantial amounts of
wood dust while operating. Failure to use a
dust collection system can result in short
and long-term respiratory illness.
Recommended CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine
the CFM at the dust port, you must consider
these variables: (1) CFM rating of the dust col-
lector, (2) hose type and length between the
dust collector and the machine, (3) number
of branches or wyes, and (4) amount of other
open lines throughout the system. Explaining
how to calculate these variables is beyond the
scope of this manual. Consult an expert or pur-
chase a good dust collection "how-to" book.
To connect a dust collection hose:
1.
Figure 32
2.
Note: A tight fit is necessary for proper
performance.
Figure 32.
Components and Hardware Needed: Qty