Filter
Top Products
G0656 8" Jointer with Built-In Mobile Base
-11-
Inventory
The following is a description of the main compo-
nents shipped with your machine. Lay the compo
-
nents out to inventory them.
Note:
If you can't find an item on this list, check
the mounting location on the machine or examine
the packaging materials carefully
. Occasionally
we pre-install certain components for shipping
purposes.
Wood Crate: (Figure
3) Qty
A. Jointer Assembly ........................................ 1
B. Cutterhead Guard ....................................... 1
C. Handwheels ................................................ 2
D. Handles ...................................................... 2
E. Fence Tilt Lever ......................................... 1
F. Push Blocks ................................................ 2
G. Knife Setting Gauge Hardware Bag
— Knife Setting Gauge Rod ........................
1
— Knife Setting Gauge Foot .......................
2
— E-Clip 8mm .............................................
2
H. Tool Hardware Bag
— Hex Wrenches 2.5, 3, 4, 6mm ......1 Each
—Open-end Wrench 8/10, 12/14mm .........
1
Cardboard Box: (Figure
4) Qty
I. Stand Assembly w/Motor and Door ........... 1
J. Pedestal Switch .......................................... 1
K. Wheel Assembly ......................................... 1
L. V-Belt .......................................................... 1
M. Dust Port ................................................... 1
Assembly Fasteners Qty
• Hex Bolt M8-1.25 x 50 (Wheel/Stand) .......
1
• Flat Washer 8mm (Wheel/Stand) ...............
1
• Hex Bolts M10-1.5 x 55 (Wheel/Stand) ......
2
• Flat Washers 10mm (Wheel/Stand) ...........
2
• Hex Nuts M10-1.5 (Wheel/Stand) ..............
2
• Cap Screws M8-1.25 x 50 (Jointer/Stand) .
3
• Flat Washers 8mm (Jointer/Stand) ............
6
• Lock Washers 8mm (Jointer/Stand) ...........
3
• Hex Nuts M8-1.25 (Jointer/Stand) ..............
3
• Flat Washers 6mm (Handwheels) ..............
2
• Cap Screws M6-1 x 12 (Handwheels) .......
2
• Set Screw M5-.8 x 12 (Cutterhead Guard)
1
• Cap Screws M8-1.25 x 25 (Pedestal) ........
2
• Lock Washers (Pedestal) ...........................
2
• Flat Washers (Pedestal) .............................
2
• Phillips Head Screws
M5-.8 x 16 (Dust Port) ................................
4
• Flat Washers 5mm (Dust Port) ..................
4
• Cap Screws M8-1.25 x 25 (Fence Suppt.) . 4
• Flat Wshers 8mm (Fence Support) ............
4
• Lock Washers 8mm (Fence Supptort) .......
4
In the event that any nonproprietary parts are
missing (e.g. a nut or a washer), we would be
glad to replace them, or for the sake of expedi
-
ency, replacements can be obtained at your local
hardware store.
Figure 3. Box 1 inventory contents.
A
B
C
D
E
F
G
H
Figure 4. Box 2 inventory contents.
J
K
L
M
SUFFOCATION HAZARD!
Immediately discard all plas-
tic bags and packing materi
-
als to eliminate choking/suf
-
focation hazards for children
and animals.
I