Grizzly G0677 Planer User Manual


  Open as PDF
of 96
 
"'%"
<%+,,')EaVcZg$HVcYZg
The pressure rollers must be set below the
level of the sanding roller. If the pressure
rollers are even, or higher than the sanding
roller, the wood WILL be propelled from the
machine at a high rate of speed toward the
front of the machine. This could cause seri-
ous kickback injury.
To check the pressure roller height:
1. 9>H8DCC:8I I=: EA6C:G$H6C9:G
;GDBI=:EDL:GHDJG8:
Pressure Roller
Height
I]ZegZhhjgZgdaaZgh]VkZWZZchZiVii]Z[VXidgn!
Wji[dghV[Zin!ndjh]djaYkZg^[ni]Vii]ZnVgZhZi
WZadli]ZaZkZad[i]ZhVcY^c\gdaaZg#
2. EaVXZ V '% adc\ 'm) d[ jc^[dgb i]^X`cZhh
VXgdhhdcZh^YZd[i]ZiVWaZhd^iheVchWdi]
i]Z [gdci VcY gZVg egZhhjgZ gdaaZgh Vi i]Z
hVbZi^bZhZZFigure 20#
Figure 20.8]ZX`^c\egZhhjgZgdaaZg]Z^\]i#
3. L^i] i]Z V^g egZhhjgZ XdccZXiZY VcY i]Z
hVcY^c\WZai^chiVaaZYVcYiZch^dcZY!bVcj"
VaangV^hZi]ZiVWaZVcYkZg^[ni]Vii]ZWdVgY
idjX]ZhWdi]egZhhjgZgdaaZghWZ[dgZ^iidjX]"
Zhi]ZhVcY^c\WZai#
4. GZeZViStep 3dci]Zdi]Zgh^YZd[i]ZXdc"
kZndgiVWaZ#
Note:If the board did not touch both pressure
rollers before it touched the sanding belt on
either side, or if it was difficult to place the
board between the rollers and the table on in
Step 4, then the pressure rollers MUST be
adjusted before operation. See "Pressure
Rollers" on Page 49 for step-by-step instruc-
tions.
 previous next