Filter
Top Products
"''"
BdYZa<%,((B[\#H^cXZ&%$&&
Adjusting Tailstock
I]ZiV^ahidX`VY_jhih^ci]ZhVbZbVccZgVhi]Z
]ZVYhidX`#
To position the tailstock along the length of
the bed:
1. AddhZci]ZiV^ahidX`adX`aZkZgVcYbdkZi]Z
iV^ahidX` id i]Z YZh^gZY edh^i^dc Vadc\ i]Z
WZY!Vhh]dlc^cFigure 19#
Figure 19.IV^ahidX`adX`aZkZgadXVi^dc#
2. GZ"Zc\V\Zi]ZiV^ahidX`adX`aZkZgidhZXjgZ
i]ZiV^ahidX`idi]ZWZY#
Note: The large clamping hex nut underneath
the tailstock will require occasional adjusting
to ensure proper clamping pressure of the
tailstock to the bed. Turn this hex nut in small
increments to fine tune the clamping pres-
sure as needed.
Always operate the lathe with the tailstock
firmly locked to the bed. Otherwise, serious
personal injury may occur by the tailstock
moving during operation and the workpiece
being ejected at high speed.
IV^ahidX`AdX`
AZkZg
Adjusting Tool Rest
I]Z idda gZhi VhhZbWan dc i]Z BdYZa <%,((
]Vh ild VY_jhiVWaZ XdbedcZcih! id egdk^YZ i]Z
hV[Zhi VcY bdhi hiVWaZ edh^i^dc l]Zc deZgVi^c\
i]ZaVi]Z#I]ZiddagZhiWVhZVY_jhih^ci]ZhVbZ
bVccZgVhi]Z]ZVYhidX`VcYiV^ahidX`#I]Zidda
gZhie^kdihVcYbVnWZVY_jhiZYkZgi^XVaan^ci]Z
iddagZhiWVhZ#
To position the tool rest assembly along the
length of the lathe bed:
1. AddhZc i]Z idda gZhi WVhZ adX` ]VcYaZ VcY
bdkZ i]Zidda gZhiVhhZbWan id i]ZYZh^gZY
edh^i^dc dc i]Z aVi]Z WZY! Vh h]dlc ^c
Figure 20#
IddaGZhi
2. GZ"Zc\V\Z i]Z idda gZhi WVhZ adX` aZkZg id
hZXjgZi]ZiddagZhiVhhZbWan^cedh^i^dc#
Note: The large clamping hex nut underneath
the tool rest base will require occasional
adjusting to ensure proper clamping pressure
of the tool rest assembly to the bed. Turn this
hex nut in small increments to fine tune the
clamping pressure as needed.
Figure 20.IddagZhiXdcigdah#
IddaGZhi
IddaGZhi
AdX`=VcYaZ
IddaGZhi7VhZ
AdX`AZkZg