Filter
Top Products
BdYZa<%,((B[\#H^cXZ&%$&&
"(&"
To outboard turn on the Model G0733:
1. 9>H8DCC:8IA6I=:;GDBEDL:G
2. GZbdkZi]ZiV^ahidX`VcYiddaWVhZ[gdbi]Z
bVX]^cZWngZbdk^c\i]Z]ZmcjihVcYXaVbe
lVh]ZghadXViZYjcYZgcZVi]i]ZVhhZbWa^Zh!
i]Zca^[i^c\i]Zb[gdbi]ZaVi]ZWZY#
3. AddhZc i]Z]ZVYhidX`! i]Zc bdkZ ^iVaa i]Z
lVnidi]ZiV^aZcYd[i]ZaVi]ZWZY!Vhh]dlc
^cFigure 42#
4. GZ"i^\]iZci]Z]ZVYhidX`idi]ZWZY#
When outboard turning, ALWAYS use a floor
mounted tool rest and keep the tool in con-
tact with the rest during all turning opera-
tions. Failure to do so could cause the tool
to be pulled out of the operator's control
and ejected at high speed.
Figure 42. Lathe prepared for outboard turning.
Sanding /Finishing
6[iZg i]Z ijgc^c\ deZgVi^dch VgZ XdbeaZiZ!
i]Zldg`e^ZXZXVcWZhVcYZYVcY[^c^h]ZY
WZ[dgZ gZbdk^c\ ^i [gdb i]Z aVi]Z! Vh h]dlc ^c
Figure 43#
Figure 43.Ine^XVahVcY^c\deZgVi^dc#
Note: Whenever sanding or finishing, move the
tool rest holder out of the way to increase per-
sonal safety and gain adequate working room.
Wrapping the sandpa-
per completely around
the workpiece could pull
your hands into the mov-
ing workpiece and may
cause serious injury.
Never wrap sandpaper
or finishing materials
completely around the
workpiece.
HVcYeVeZg
Ldg`e^ZXZ