Filter
Top Products
-10-
Model G0704 (Mfg. Since 0 8/11)
Additional Safety for Mill/Drills
UNDERSTANDING CONTROLS. Make sure you
understand the use and operation of all controls.
SAFETY ACCESSORIES. Always use a chip
guard in addition to your safety glasses when mill-
ing/drilling to prevent bodily injury.
WORK HOLDING. Before starting the machine,
be certain the workpiece has been properly
clamped to the table. NEVER hold the workpiece
by hand when using the mill/drill.
CHUCK KEY SAFETY. Always remove your
chuck key, drawbar wrench, and any service tools
immediately after use.
SPINDLE SPEEDS. Select the spindle speed
that is appropriate for the type of work and mate-
rial. Allow the mill/drill to gain full speed before
beginning a cut.
POWER DISRUPTION. In the event of a local
power outage during use of the mill, drill turn OFF
all switches to avoid possible sudden start up
once power is restored.
SPINDLE DIRECTION CHANGES. Never reverse
spindle direction while the spindle is turning.
MACHINE CARE AND MAINTENANCE. Never
operate the mill/drill with damaged or worn parts.
Maintain your mill/drill in proper working condition.
Perform routine inspections and maintenance
promptly. Put away adjustment tools after use.
STOPPING SPINDLE. DO NOT stop the mill/drill
using your hand against the chuck.
BE ATTENTIVE. DO NOT leave the mill/drill run-
ning unattended for any reason.
DISCONNECT POWER. Make sure the mill/drill is
turned OFF, disconnected from its power source
and all moving parts have come to a complete
stop before starting any inspection, adjustment,
or maintenance procedure.
AVOIDING ENTANGLEMENT. Keep loose cloth-
ing articles such as sleeves, belts or jewelry items
away from the spindle. Never wear gloves when
operating the mill/drill.
TOOL HOLDING. Always use the proper tools
for the material you are machining. Make sure
they are held firmly in the proper tool holder for
the job.
CLE AN -U P. DO NOT clear chips by hand. Use a
brush, and never clear chips while the spindle is
turning.
CUTTING TOOL INSPECTION. Inspect drills and
end mills for sharpness, chips, or cracks before
each use. Replace dull, chipped, or cracked cut-
ting tools immediately. Handle new cutting tools
with care. Leading edges are very sharp and can
cause lacerations.
EXPERIENCING DIFFICULTIES. If at any time
you are experiencing difficulties performing the
intended operation, stop using the machine!
Contact our Technical Support at (570) 546-
9663.
No list of safety guidelines can be complete. Every shop environment is different. Like all
machines there is danger associated with the Model G0704. Accidents are frequently caused by
lack of familiarity or failure to pay attention. Use this machine with respect and caution to lessen
the possibility of operator injury. If normal safety precautions are overlooked or ignored, serious
personal injury may occur.