Filter
Top Products
-14-
Model G0704 (Mfg. Since 0 8/11)
Inventory
Contents Qty
A. Mill/Drill w/Stand ......................................... 1
B. Open End Combo Wrench 17/19 ................ 1
C. Open End Combo Wrench 8/10 ................. 1
D. Bottle for Oil ............................................... 1
E. Tool Box...................................................... 1
F. Large Handwheel Handle ........................... 1
G. Small Handwheel Handles ......................... 3
H. T-Bolts M10-1.5 x 60 (vise mounting) ......... 2
Flat Washers 10mm (vise mounting) .......... 2
Hex Nuts M10-1.5 (vise mounting).............. 2
I. Drill Chuck .................................................. 1
J. Chuck Key .................................................. 1
K. Phillips Screwdriver .................................... 1
L. Flat Screwdriver .......................................... 1
M. Arbor B16 x R8 ........................................... 1
N. Hex Wrench Set 2, 3, 4, 5, & 6mm ...... 1 ea.
O. Spindle Pin ................................................. 1
Not Shown:
Hex Bolts M10-1.5 x 50 .............................. 4
Flat Washers 10mm ................................... 4
Figure 4. G0704 out of the crate.
A
Figure 5. Inventory.
B
D
E
GH
IJ
LK
M
C
F
N
O
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.