Filter
Top Products
-16- G1014Z Combination Sander
Horizontal Sanding
1. Turn the sander on and allow the belt to
reach full speed.
2. Place the workpiece flat on the belt. Be sure
to hold the work securely with both hands.
Place one hand at the end of the workpiece
to feed it against the rotation of the belt, and
one hand lightly on top of the piece to ensure
adequate stock removal. Figure 20.
3. Depending on the length of the workpiece,
use the back stop to prevent it from being
ejected by the belt. If your workpiece is too
long, simply remove the back stop.
Figure 20.
SECTION 6: OPERATIONS
Once assembly is complete and adjustments are
done to your satisfaction, you are ready to test
the machine.
Turn on the power supply at the main panel.
Press the START button. Make sure that your fin-
ger is poised on the STOP button, just in case
there’s a problem. The sander should run
smoothly, with little or no vibration or rubbing
noises. Strange or unnatural noises should be
investigated and corrected before operating the
machine further.
WARNING: DO NOT attempt to investigate or
adjust the machine while it is running. Wait until
the machine is turned off, unplugged and all
working parts have come to a rest before you do
anything!
If noises occur that cannot be found by visual
inspection, feel free to contact our service depart-
ment for help.
Test Run