Filter
Top Products
-18-
G0500/G1018/G1018HW 8" Jointers
To mount the jointer to the stand:
1. Lift the main unit onto the stand and position
the cutterhead pulley over the pulley slot in
the top of the stand.
2. Carefully align the mounting holes in the
stand (shown in Figure 17) with the threaded
holes in the base of the jointer.
3. Secure the jointer to the stand using the (3)
3
⁄8"-16 x
3
⁄4" hex bolts and
3
⁄8" flat washers pro-
vided. Be sure not to over-tighten!
Jointer to Stand
The jointer unit is very
heavy—get assistance
when lifting it onto the
stand. Serious personal
injury may occur if safe
moving methods are not
followed.
Figure 18. Motor adjustment bolts (shown
underneath stand for clarity).
To install the V-belt:
1. Open the stand cover to access the motor
adjustment bolts.
2. Loosen the motor adjustment bolts shown in
Figure 18, and slide the motor up until you
can attach the V-belts to the pulleys.
V-Belt
Figure 16.
Jointer stand floor mounting flanges.
If you will be placing the jointer on a mobile base,
set the stand on the mobile base before installing
the jointer unit onto the stand.
If you will be bolting the stand to the floor, posi-
tion the stand in its proper location and secure it
to the floor, using fasteners through the mounting
flanges shown in Figure 16, before installing the
jointer unit on the stand.
Figure 17.
Jointer unit mounting holes.
3. Allow the weight of the motor to rest against
the V-belts.