Filter
Top Products
-10- G1019 14'' Bandsaw
Stand
SECTION 4: ASSEMBLY
The Model G1019 Bandsaw stand is an A-frame,
panel-style stand. The front and rear panels are
connected with one panel at the top and two
cross braces near the bottom.
Sometimes sheet metal parts have a tendency to
''spring'' after they are formed. For this reason,
you may need to use a little extra force to align
holes to insert bolts.
Figure 3. Attach rubber feet first.
1. Start with the stand panel with the switch
mounted in it. Turn the panel upside down
and attach the rubber feet using (2)
1
⁄4''-20 x
1'' Phillips
®
head screws, (2) flat washers
and (2) hex nuts provided. Tighten down.
See Figure 3. Repeat this step with the
second stand panel.
Keep clothing rolled up
and out of the way of
machinery and keep
hair pulled back.
Wear safety glasses dur-
ing the entire assembly
process. Failure to com-
ply may result in serious
personal injury.
Some metal parts may
have sharp edges on
them after they are
formed. Please examine
the edges of all metal
parts before handling
them. Failure to do so
could result in injury.
Disconnect power to the
machine when perform-
ing any maintenance or
assembly. Failure to do
this may result in serious
personal injury.