Filter
Top Products
-18- G1023SL/G1023SLX Left-Tilting 10'' Table Saw
2. Set a machinist’s square against the face of
the blade splitter. Slightly rotate the rear
bracket to adjust the face of the blade splitter
perpendicular to the table top as shown in
Figure 18.
Figure 17. Blade guard and splitter in place.
Blade Guard/Splitter
1. Slip the blade guard/splitter over the mount-
ing bolts as shown in Figure 17. The wash-
ers should be between the bolt head and the
slots. Tighten the bolts to secure the blade
guard/splitter.
Figure 16. Dust port installed on cabinet.
Anti-kickback Pawl
Blade Guard
Saw Blade
Dust Port
Please review this section even if your saw blade
came pre-installed. To install the blade:
1. Remove the table insert to gain access to the
arbor.
2. Remove the nut and the outer arbor flange
from the arbor.
3. Place the blade on the arbor, making sure
that it seats firmly against the inner arbor
flange. Ensure that the top blade teeth are
facing the front of the saw.
The saw blade is extremely sharp. Use extra
care when handling the blade or working
near it. Serious injury is possible.
Mount the the dust port onto the cabinet stand
with the 4 Phillips
®
screws as shown in Figure
16.
4. Replace the outer arbor flange and rethread
the arbor nut onto the arbor.
5. Hand tighten the nut and snug with the
wrench included with the saw. DO NOT
overtighten.
IMPORTANT: Make sure the blade is installed
with the teeth facing the front of the saw.
Mounting Bolts