Filter
Top Products
Figure 6. Mounting brackets to base.
G1028/G1029 Dust Collector -11-
Figure 7. Mounting collector to brackets.
Support Brackets
There are two lower collector support brackets
and one upper bag support bracket. Attach the
collector brackets to the top edge of the base
plate using four (4)
5
⁄16" - 18 x
1
⁄2" bolts provided.
Figure 6.
Collector
The collector attaches to each support bracket.
The inside of the collector is funnel shaped and
directs the air around in a cyclone motion. Make
sure that the inside taper (funnel) is faced down-
ward and the collector inlet faces toward the col-
lector body.
Secure the front support bracket to the collector
with two (2)
5
⁄16" - 18 x
3
⁄4" bolts provided. Before
securing the rear support bracket to the collector,
line up the upper bag support bracket bolt holes
with the collector support bracket bolt holes and
collector. Secure with two (2)
5
⁄16" - 18 x
3
⁄4" bolts
provided. Figure 7.