Filter
Top Products
-2- G1030 Dust Collector
Safety Instructions For Power Tools
SECTION 1: SAFETY
7. DON’T FORCE TOOL. It will do the job
better and safer at the rate for which it was
designed.
8. USE RIGHT TOOL. Don’t force tool or
attachment to do a job for which it was not
designed.
9. USE PROPER EXTENSION CORD.
Make sure your extension cord is in good
condition. When using an extension cord,
be sure it is rated Hard Service (grade S)
or better. Conductor size must be 16
A.W.G. for cords up to 100 feet in length.
An undersized cord will cause a drop in
line voltage resulting in loss of power and
overheating. Your extension cord must
also contain a ground wire and plug pin.
Always repair or replace extension cords if
they become damaged. Minimum Gage
for extension cord:
16 A.W.G. 50ft
16 A.W.G. 100ft
14 A.W.G. 200ft
12 A.W.G. 300ft
1. KEEP GUARDS IN PLACE and in work-
ing order.
2. REMOVE ADJUSTING KEYS AND
WRENCHES. Form habit of checking to
see that keys and adjusting wrenches are
removed from tool before turning on.
3. KEEP WORK AREA CLEAN. Cluttered
areas and benches invite accidents.
4. DON’T USE IN DANGEROUS ENVIRON-
MENT. Don’t use power tools in damp or
wet locations, or where any flammable or
noxious fumes may exist. Keep work area
well lighted.
5. KEEP CHILDREN AND VISITORS
AWAY. All children and visitors should be
kept a safe distance from work area.
6. MAKE WORK SHOP CHILD PROOF with
padlocks, master switches, or by removing
starter keys.
For Your Own Safety Read Instruction
Manual Before Operating This Equipment
Always wear eye protection.
Always keep cutter head and belt guards in
place and in proper operating condition.
Never make jointing, planing, or rabbeting cut
deeper than
1
⁄8'' inch.
Maintain the proper relationships of infeed
and outfeed table surfaces and cutter head
knife path.
Support the workpiece adequately at all times
during operation; maintain control of the work at
all times.