Grizzly G1066Z Sander User Manual


 
-6- G1066/G1066Z/G1079 Drum Sander
The Model G1066/G1066Z/G1079 comes pre-
wired for 220 volt operation. Wiring diagrams are
provided at the back of this manual should it be
necessary to repair or revise the wiring. Always
consult a qualified electrician when doing any
electrical work on this equipment.
Wiring Diagram
We have covered some basic electrical
requirements for the safe operation of your
Sander. These requirements are not neces-
sarily comprehensive. You must be sure
that your particular electrical configuration
complies with local and state codes.
Ensure compliance by checking with your
local municipality or a licensed electrician.
Extension Cords
We do not recommend the use of extension
cords on 220V equipment. It is much better to
arrange the placement of your equipment and the
installed wiring to eliminate the need for exten-
sion cords. Should it be necessary to use an
extension make sure the cord is rated Hard
Service (grade S) or better. Refer to the chart in
Section 1: Safety to determine the minimum
gauge for the extension cord. The extension cord
must also contain a ground wire and plug pin.
Always repair or replace extension cords when
they become worn or damaged.