Filter
Top Products
G1128/G1129 Power Feeders -11-
Figure 6.
2. Loosen the lock handles on the pivot joint
assembly.
3. Rotate head to the desired position.
4. Adjust the height and distance from the
fence.
5. Re-tighten the lock handles.
As with the previous arrangement, you will want
to set the distance between the rollers and (in this
case) the fence about
1
⁄8" to
3
⁄16" under the thick-
ness of the material to be milled. The rollers
should also be skewed slightly toward the direc-
tion of feed to hold the workpiece against the
table. Figure 6. When using the power feeder this
way, it is essential to make sure that the fence is
fastened tightly in place.
The power feeder can also be set to support your
work against a fence. Figure 5.
1. Raise the horizontal shaft so that when the
power feeder head is turned, there will be no
interference with the fence.
Figure 4.
Figure 5.
4. Set the wheel height between
1
⁄16" and
1
⁄8"
below the height of the material you intend to
mill. The wheels, when properly adjusted,
will put consistent downward pressure on
your workpiece. Figure 4.