Grizzly G4791 Lathe User Manual


  Open as PDF
of 96
 
<),.&&'m(.AVg\Z8dbWdAVi]Z$B^aa
"(("
4. L^i] Vhh^hiVcXZ id ]daY i]Z ldg`e^ZXZ ^c
eaVXZ!i^\]iZcZVX]_Vl^chbVaa^cXgZbZcih#
5. 6[iZg VY_jhi^c\ i]Z [^ghi _Vl! Xdci^cjZ i^\]i"
Zc^c\ ^c deedh^c\ hZfjZcXZ! Vh h]dlc ^c
Figure 34!jci^ai]Zldg`e^ZXZ^h[^gbanhZXjgZ
^ci]ZYZh^gZYedh^i^dc#
&
'
(
)
m
Figure 34.I^\]iZc^c\hZfjZcXZ[dgi]Z)"_Vl
X]jX`#
Figure 35.:mVbeaZd[Va^\c^c\ldg`e^ZXZl^i]V
iZhi^cY^XVidgdcV)"_VlX]jX`#
Figure 36.:mVbeaZd[i]Z[VXZeaViZl^i]
egdeZganbdjciZYldg`e^ZXZXaVbeZY^c[djg
adXVi^dch#
6. BV`ZVXXjgViZVY_jhibZcihidi]Zldg`e^ZXZ
edh^i^dcWnjh^c\ViZhi^cY^XVidgVcYVY_jhi"
^c\ i]Z_Vlh jci^ai]Z ldg`e^ZXZ^h egZX^hZan
Va^\cZYhZZFigure 35[dgVcZmVbeaZ#
Always use a low spindle speed when
machining non-cylindrical or off-center
workpieces to avoid ejecting the workpiece
from the holding device at a high rate of
speed. Failure to heed this warning could
lead to serious personal injury, death or
property damage.
Faceplate
I]Z[VXZeaViZXVcWZjhZY[dgbdjci^c\cdc"Xna^c"
Yg^XVa eVgih dg [dg d[["XZciZg ijgc^c\ Wn XaVbe^c\
i]Zldg`e^ZXZid^i#GZ[Zgidi]ZACCESSORIES
hZXi^dcdcPage 50[dgXaVbe^c\dei^dch#
To mount a workpiece to the faceplate:
1. 9>H8DCC:8IB68=>C:;GDBEDL:G
2. EaVXZVe^ZXZd[eanlddYjcYZgi]Z[VXZeaViZ
idegdiZXii]ZWZYlVnh#
3. L^i] Vhh^hiVcXZ! eaVXZ i]Z ldg`e^ZXZ dcid
i]Z[VXZeaViZVcYXaVbe^ii^\]ian^ceaVXZl^i]
V b^c^bjb d[ i]gZZ ^cYZeZcYZci XaVbe^c\
YZk^XZhhZZFigure 36[dgVcZmVbeaZ#
Note: Take into account the rotation and
cutting forces that will be applied to the
workpiece when clamping it to the faceplate.
 previous next