Filter
Top Products
G6048 15/16 Gauge Nailer
-6-
OPERATION
Loading Nailer
To load your nailer:
1. Disconnect the air supply from the
nailer!
2. Flip the magazine latch in the direc-
tion shown in Figure 1.
3. Pull back the magazine cover until it
stops.
4. Point the nailer down and insert a
stick of nails into the magazine as
shown in Figure 2. Make sure the
pointed ends of the nails rest in the
slot at the bottom of the magazine.
Figure 1. Releasing magazine latch.
Figure 2. Loading brad nails into nailer.
5. Push the magazine cover forward
until the magazine latch locks in
place.
Single/Bump Fire Mode
The Model G6048 is equipped with a sin-
gle/bump fire trigger.
To select single or bump fire operation:
1. Disconnect the air supply from the
nailer!
2. Locate the hex nut that secures the
safety yoke mechanism to the trigger
housing. See Figure 3.
3. To select Single Fire mode, tighten
the hex nut completely.
4. To select Bump Fire mode, unthread
the hex nut at least two full turns.
Figure 3. Single/bump fire adjustment.
When replacing nails for your Model
G6048, follow these guidelines:
Gauge: 15/16
Length:
3
⁄4"-2
1
⁄2"
Capacity: 100 Nails
Adjustment
Hex Nut