Filter
Top Products
G6048 15/16 Gauge Nailer
-8-
Always disconnect air from nailer
whenever clearing a jammed nail!
Clearing Jammed Nails
The most frequent situation with any type
of nailer is a nail jam. A jammed nail must
be cleared before using the nailer again.
The two places where a nail can get
jammed are the magazine and the dis-
charge area.
Figure 5. Removing guide cover.
Quick Release Latch
To clear a jammed nail from the magazine:
1. Disconnect the nailer from the air
supply!
2. Open the magazine cover and pull the
magazine all the way back.
3. Locate and remove the jammed brad
nail with a pair of needle nose pliers.
Close the magazine cover so it latch-
es.
Driver Guide Cover
To clear a jammed nail from the discharge
area with the Model G6048:
1. Disconnect the nailer from the air
supply!
2. Remove all of the brad nails from the
magazine.
3. Flip up the quick release latch that is
located on top of the nailer nose
assembly as shown in Figure 5.
4. Remove the driver guide cover.
5. The jammed nail should now be visi-
ble; remove it from the discharge area
with needle nose pliers.
6. Replace the driver guide cover and
snap the quick release latch back into
operating position.