Filter
Top Products
G6049 14/15 Gauge Angle Finish Nailer Kit-6-
OPERATION
Loading Nailer
To load your nailer:
1. Disconnect the air supply from the
nailer!
2. Load nails at the top of the magazine
in the T-slot as shown in Figure 1.
3. Slide the stick of nails all the way
down to the nose of the nailer.
4. Pull the magazine pusher all the way
back, then let it come forward until it
catches on the end of the nail stick.
Figure 1. Loading the nailer (side view
and end view). Match nail heads with
head slot for insertion.
Single/Bump Fire Mode
The Model G6049 is equipped with a sin-
gle/bump fire trigger.
To select single or bump fire operation:
1. Disconnect the air supply from the
nailer!
2. Locate the hex nut that secures the
safety yoke mechanism to the trigger
housing. See Figure 2.
3. To select Single Fire mode, tighten
the hex nut completely.
4. To select Bump Fire mode, unthread
the hex nut at least two full turns.
Figure 2. Single/bump fire adjustment.
Adjustment
Hex Nut
When replacing nails for your Model
G6049, follow these guidelines:
Gauge: 14/15
Length: 1
1
⁄4"-2
1
⁄2"
Capacity: 100 Nails