Filter
Top Products
G6049 14/15 Gauge Angle Finish Nailer Kit-8-
Always disconnect air from nailer
whenever clearing a jammed nail!
Clearing Jammed Nails
The most frequent situation with any type
of nailer is a nail jam. A jammed nail must
be cleared before using the nailer again.
Figure 5. Removing guide cover.
Quick
Release
Latch
Driver
Guide
Cover
To clear a jammed nail from the discharge
area with the Model G6049:
1. Disconnect the nailer from the air
supply!
2. Push the finger tab inside the maga-
zine pusher, pull the pusher back
slightly to clear it from the nail stick
and allow it to come all the way for-
ward, near the nose.
3. Push down the backstop inside the
magazine and slide the nail stick out
of the back of the magazine.
4. Flip up the quick release latch located
on top of the nailer nose assembly as
shown in Figure 5.
5. Remove the driver guide cover.
6. The jammed nail should now be visi-
ble; remove it from the discharge area
with needle nose pliers.
7. Replace the driver guide cover and
snap the quick release latch back into
operating position.