Filter
Top Products
-20-
G7211/7212 24" Bandsaw
SECTION 7: MAINTENANCE
V-Belts
To ensure optimum power transmission from the
motor to the blade, the V-belt must be in good
condition and operate under proper tension. Belts
should be checked for cracks, fraying and wear.
Belt tension should be checked at least every 3
months; more often if the bandsaw is used daily.
The V-belts are accessed via the bottom cover:
1. Squeeze the center of each V-belt.
2. Note the amount of deflection. Deflection
should be approximately
3
⁄4".
The table and other non-painted surfaces on the
Model G7211/7212 should be protected against
rust and pitting. Wiping the saw clean after every
use ensures that moisture from wood dust isn’t
allowed to trap moisture against bare metal sur-
faces.
Some woodworkers recommend using automo-
tive paste wax on exposed steel and cast iron sur-
faces. The wax provides a layer of protection, as
well as reducing friction between lumber and the
table, making cuts faster and smoother. Avoid
waxes that contain silicone or other synthetic
ingredients. These materials can find their way
into lumber that’s being worked, and can make
staining and finishing difficult. If you use paste
wax, make sure that it’s 100% Carnauba wax.
NOTICE
Do not use paraffin or similar waxes on your
saw’s table. They can leave residues which
will make cutting more difficult over time. Do
not use silicon based lubricants. They can
rub off onto the wood and prevent it from
taking stains and finishes properly.
Table
Operating this equipment has the potential
to propel debris into the air which can cause
eye injury. Always wear safety glasses or
goggles when operating equipment.
Everyday glasses or reading glasses only
have impact resistant lenses, they are not
safety glasses. Be certain the safety glasses
you wear meet the appropriate standards of
the American National Standards Institute
(ANSI).
DO NOT make adjustments or attempt main-
tenance procedures while the Model
G7211/G7212 is running. Ensure that the
switch is off, power is disconnected and
moving parts have stopped before making
adjustments. Failure to comply may result
in serious personal injury.