Filter
Top Products
Ultimate Series Jointers-6-
Model
G9953/G9953ZX
Figure 1. NEMA-style L6-20 plug and outlet.
Voltage & Amperage Draw
The Model G9953/G9953ZX features a 5 HP
motor and is wired to operate on a single-phase,
220V circuit. The motor will draw the following
load:
Motor Load ............................................28 Amps
Plug Type
The cord set enclosed does not have a plug as
the style of plug you require will depend on the
type of service you currently have or plan to
install. We recommend using the following plugs
for your machine on a dedicated circuit only (see
Figure 1 for an example).
Recommended Plug ......................6-30 or L6-30
Circuit Breaker Requirements
Use the following guidelines when choosing a cir-
cuit breaker (circuit breakers rated any higher are
not adequate to protect the circuit):
Circuit Breaker ............................30 Amp, 2 Pole
Your Circuit Capacity
Always check to see if the wires in your circuit are
capable of handling the amperage draw from
your machine, as well as any other machines that
could be operating on the same circuit. If you are
unsure, consult a qualified electrician.
If the circuit breaker trips or the fuse blows regu-
larly, your machine may be operating on a circuit
that is close to its amperage draw capacity.
However, if an unusual amperage draw does not
exist and a power failure still occurs, contact a
qualified electrician or our service department at
(570) 546-9663.
Serious personal injury could occur if you
connect your machine to the power source
before you have completed the assembly
process. DO NOT connect the machine to
the power source until instructed to do so.
SECTION 3: CIRCUIT REQUIREMENTS