Filter
Top Products
-12- G9984/G9985 Oscillating Belt Edge Sander
SECTION 4: ASSEMBLY
Most of your Model G9984/G9985 has been
assembled at the factory, but some parts must be
assembled or installed after delivery.
TOOLS REQUIRED: You will need a small
adjustable wrench, a flat and Phillips head screw-
driver, and a machinist’s square.
Four rubber feet are furnished to help absorb
machine vibration, to even out imperfections in
the floor, and to protect the machine from general
stress. To install the rubber feet:
1. Thread the end of the rubber feet into the
threaded holes on the underside of the base
supports as shown in Figure 6.
2. Do not overtighten the feet. Cast iron threads
are softer than the steel threads on the feet.
Overtightening can cause the cast iron
threads to become stripped.
Rubber Feet
Figure 6. Attaching rubber feet.
Disconnect power to the
machine when perform-
ing any assembly proce-
dures on the Model
G9984/G9985. Failure to
do this may result in seri-
ous personal injury.
!
Keep loose clothing
rolled up and out of the
way of machinery and
keep hair pulled back.
Wear safety glasses dur-
ing the entire assembly
process. Failure to com-
ply may result in serious
personal injury.
Some metal parts may
have sharp edges on
them after they are
formed. Please examine
the edges of all metal
parts before handling
them. Failure to do so
could result in injury.
Beginning Assembly