Filter
Top Products
-10-
Model G9986 8" Drill Press
The unpainted surfaces are coated with a waxy
oil to protect them from corrosion during ship
-
ment. Remove this protective coating with a sol
-
vent cleaner or citrus-based degreaser such as
Grizzly’s G7895 Degreaser. To clean thoroughly,
some parts may need to be removed. For opti
-
mum performance from your machine, make
sure you clean all moving parts or sliding
contact surfaces that are coated. Avoid chlo
-
rine-based solvents, such as acetone or brake
parts cleaner, as they may damage painted sur
-
faces should they come in contact. Always follow
the manufacturer’s instructions when using any
type of cleaning product.
Clean Up
Gasoline and petroleum
products have low flash
points and could cause
an explosion or fire if
used to clean machinery.
DO NOT use gasoline or
petroleum products to
clean the machinery.
Many of the solvents
commonly used to clean
machinery can be toxic
when inhaled or ingest
-
ed. Lack of ventilation
while using these sol
-
vents could cause seri
-
ous personal health risks
or fire. Take precautions
from this hazard by only
using cleaning solvents
in a well ventilated area.
Assembly
The drill press cannot be safely operated unless
it is properly assembled.
To assemble the drill press:
1. Mount the column to the base with the three
included hex bolts and flat washers (
Figure
5).
Figure 5. Column secured to base.
2. Slide the table assembly over the column and
lock into place with the swivel handle (
Figure
6).
Figure 6. Table assembly installed on column.