Filter
Top Products
H0604 Cutting Tool
-5-
Regular periodic maintenance on your
H0604 will ensure its optimum perfor-
mance. Make a habit of inspecting your
tool each time you use it. Check for the fol-
lowing conditions and repair or replace
when necessary:
1. Loose fasteners.
2. Worn switch.
3. Worn or damaged cords and plugs.
4. Any other condition that could ham-
per the safe operation of this
machine.
Since this tool is encased in a double insu-
lated plastic cover, leave repair and ser-
vice issues to a qualified service techni-
cian. This includes brush replacement,
lubrication or any other internal operation.
Ensure that no air passages get blocked. If
they do, blow them out with compressed
air. WARNING: Wear safety glasses when
cleaning tool with compressed air.
Plastic parts can easily be cleaned with a
damp cloth, but never use water to clean
any electrical parts. Solvents should also
be avoided on plastic because of the pos-
sibility of damage.
MAINTENANCE
Disassembly and improper reassem-
bly of this device can result in electri-
cal shock danger. Always have this
device serviced by an qualified elec-
trical repair technician. Serious injury
will result.
The potential for injury using this
device is great. Use extreme caution
and care when operating, adjusting and
maintaining this saw. Failure to observe
safe handling practices will result in
serious personal injury.
Operating Guides and Tips
Avoid overloading the cutting tool
Always use sharpened cutting bits.
Do not apply excessive pressure to
the cutting tool while using. If the
speed drops abnormally, decrease
pressure immediately. If the bit stops
abruptly or becomes blocked,
release the trigger at once.
Ensure the safety of the workplace.
Clear the work area of all parts and
debris that may cause injury by flying
objects. Securely fix the object to be
cut or fastened in a vise or otherwise
clamp to avoid injury. Do not attempt
to hold workpiece by hand.
Inspect the cutting tool before use. Run
the cutting tool before using to
ensure all parts are running smooth-
ly and there are no abnormal sounds
or sparks. If any defect is found,
have unit serviced.
Know your worksite. Only cut as deep as
necessary. Check behind walls for
wires, other electrical hazards, or
plumbing.
Maintenance