Filter
Top Products
-12-
H2669 Hobby Lathe
Test Run
When assembly is complete, test run your
machine to make sure it runs properly.
To test run the machine:
1. Make sure you have read and understand
the safety instructions given at the beginning
of this manual.
2. Make sure the machine is setup properly.
3. Make sure all tools and objects used during
setup are clear of the machine
4. Connect the drill to the power source.
5. Turn the drill ON.
6. Listen for abnormal noises and watch care-
fully for abnormal actions. The machine
should run smoothly with little vibration or
rubbing noises.
—If the machine runs smoothly with little
or no vibration and no rubbing noises,
then turn the drill OFF and proceed to
OPERATIONS on Page 12.
—If, during the test run, you cannot easily
locate the source of an unusual noise or
vibration, then turn the drill
OFF imme-
diately and review
Troubleshooting on
Page 18. If you still cannot remedy a prob-
lem, contact our Tech Support at (570)
546-9663 for assistance.
7. Re-mount the tailstock to the lathe bed as
shown in Figure 10. Position it temporarily a
few inches from the end of the lathe bed and
hand tighten the hex head bolt.
Figure 10. Mounting the tailstock.
Hex Head Bolt