Filter
Top Products
H2669 Hobby Lathe
-13-
Using this machine without proper protec-
tive gear could result in
damage to your
eyes, lungs, and ears. Always wear safety
glasses, a respirator, and hearing protection
when operating this machine.
Operation Safety
SECTION 4: OPERATIONS
NOTICE
If you have never used this type of machine
or equipment before, WE STRONGLY REC
-
OMMEND that you read books, trade maga
-
zines, or get formal training before begin
-
ning any projects. Regardless of the con
-
tent in this section, Grizzly Industrial will
not be held liable for accidents caused by
lack of training.
Tie back long hair, roll
up long sleeves and
remove loose clothing,
jewelry or gloves to
avoid being pulled into
moving parts.
Operations
The Model H2669 Hobby Lathe will perform many
tasks, including spindle and faceplate turning as
well as disc sanding.
This section will guide you through setup for a
typical spindle turning application.
To setup for spindle turning:
1. DISCONNECT THE ELECTRIC DRILL
FROM THE POWER SOURCE.
2. Mark both ends of your workpiece by draw-
ing diagonal lines from corner to corner. The
intersection point of these lines will show you
the center of your workpiece. See Figure 11
for details.
Note: 24" is the maximum length of stock you
can turn with your hobby lathe and 6" is your
maximum end width.
Figure 11. Workpiece marked diagonally across
corners to determine the center.