Filter
Top Products
H3141 Heavy-Duty Planer
-6-
Planing
1. Unplug the planer from the power
source!
2. Set the planer on a flat surface such
as a workbench.
3. Turn the depth control knob until both
the infeed and outfeed soles are flat
against the workbench.
4. While keeping the outfeed sole flat
against the workbench, turn the depth
control knob to raise the infeed sole off
of the workbench. Note–The differ-
ence in height between the infeed and
outfeed soles will be the depth of cut
(See Figure 7).
5. Plug the planer into a suitable power
source. Review the Electrical sec-
tion.
6. If the fence will be used, attach the
fence to the planer and adjust it to the
desired width of cut.
7. Make sure all knobs are secure.
8. The planer is ready to be operated!
OPERATION
Figure 7. Depth of cut.
Failure to wear safety glasses while
operating the grinder could cause
serious personal eye injury.